MHP TJK - Manual (Page 11)

11
Mountings
OPTION: For OPTIMUM Cart Only: (Fig. 12)
1. Attach the wheels by slipping the axle through the
base, slide the wheels on and secure with the axle
clips. Finish by snapping the hub caps on before
standing unit upright.
Step 3: Connect the Grill Head Bottom (Fig. 13)
1 . Attach the grill head bottom to the pedestal column
top with four ¼ - 20 x1 ½" Hex bolts, washers under
the bolt head and Kep nuts. Peel the remaining
protective coating off the pedestal column.
When you complete the mount assembly go to the
appropriate Grill Assembly Section and assemble
the grill head.
Step 4: Attaching the Access Panel (Fig. 14)
Note: Do not attach the front access panel until
the control panel has been attached to the
grill head bottom and the gas supply line
has been properly connected and leak
tested.
1. The front access panel attaches directly under the
control panel and hides the access opening. Lift
the access panel up behind the lip of the control
panel, then slip the bottom double edge of the ac-
cess panel (upward pressure may be needed) over
the edge of the access opening.
Caution: Combustible material should never be
within 24 inches of the top, bottom, back or sides
of your MHP Gas Barbecue Grill.