Matsushita MBS0407S0 - Manual (Page 38)

FAQs, etc.
•
Frequently
Asked Questions
37
Problem Actions
Screen
Sound
HDMI
The remote control
does not work
•
Are the batteries installed correctly? (p. 6) •
Has the TV been switched On?
TV goes into
“Standby mode”
•
Off Timer function is activated. •
The TV enters “Standby mode” about 30 min. after broadcasting
ends.
Unusual image is displayed
•
Turn off the TV with Mains power On / Off switch, then turn it on
again.
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
•
Is the HDMI cable connected properly? (p. 30) •
Turn Off the TV and equipment, then turn them On again. •
Check an input signal from the equipment. (p. 35) •
Use an equipment compliant with EIA/CEA-861/861B.
Sound is unusual
•
Set the sound setting of the connected equipment to
“2ch L.PCM”. •
Check the “HDMI1 Input” setting in the Sound Menu. (p. 20) •
If digital sound connection has a problem, select analogue sound
connection. (p. 34)
Sound level is low
or sound is distorted
•
Sound signal reception may be deteriorated. •
Check Sound system. (p. 23)
No sound is produced
•
Is “Sound mute” active? (p. 7) •
Is the volume set to the minimum?
Blurry or distorted image
(no sound or low volume)
•
Reset channels. (p. 23)
No image can be
displayed
•
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
(p. 20) •
Check Colour system. (p. 23)
Chaotic image, noisy
•
Set “P-NR” in the Picture Menu (to remove noise). (p. 20) •
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
Other