Philips Magnavox 20MS334R - Manual (Page 7)

7
1
ANT 75‰
Y our Cable TV signal into your home may be a
single, 75
Ω
(ohm) cable. If so, this connection
is very simple. Follow the step below to connect
your Cable TV signal to your new television.
1 Connect the Cable TV signal to the
75
Ω
jack on the TV. Screw it down fin-
ger tight.
B
ASIC
C
ABLE
TV C
ONNECTION
Cable TV signal from
Cable Company
(75
Ω
coaxial cable)
A combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69).Your connection is easy
because there is only one 75
Ω
(ohm)
antenna jack on the back of your TV, and
that’s where the antenna goes.
1 If your antenna has a round cable
(75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the
screws on a 300- to 75-ohm adapter.
2 Connect the antenna (or adapter)
to the 75
Ω
(ohm) jack on the back of
the TV. If the end of the antenna wire
is threaded, screw it down finger tight.
B
ASIC
A
NTENNA
C
ONNECTION
Use Auto Program as described on page 12
to set up channels that are available in your
area. Use the CH +/– buttons to scan avail-
able channels.
H
ELPFUL
H
INT
1
ANT 75‰
2
Antenna
with 75 Ω
cable
OR
Twin-lead
wire to
300-75
Ω
adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
75
Ω
jack on rear
of Television
75
Ω
jack on rear
of Television