Handicare MB3150-GB - Manual (Page 20)

20
A
B
A
B
A
70º
80º 90º
MB3150-GB
Figure 38
Figure 39
Figure 37
Adjusting the anti-tip stabiliser
Figure 37
Adjust the anti-tip stabiliser when you
have changed the centre of gravity of the
wheelchair. Loosen screw (37A). Pull or
push the anti-tip stabiliser to the correct
position so that the measurement on the
stabiliser’s measuring scale corresponds to
the driving wheel position. Re-tighten the
screw. There should be a maximum of 37
mm from the end of the anti-tip stabiliser to
the base. To adjust this, loosen the screw
(37B) and push/pull the lower pipe of the
anti-tip stabiliser. Re-tighten the screw.
Adjusting the length of the
legrests
Figure 38
The leg supports have a linear scale (38A)
on the outside, which helps to achieve the
correct length. To adjust the length of the
leg supports loosen the fixing screw (38B)
approx. 5 mm. Then adjust the leg supports
to the desired length and re-tighten the
screw.
A quick-release catch for adjusting the leg
supports is available as an accessory (see
page 34).
Adjusting the angle of the
legrests
Figure 39
The angle of the legrests can be adjusted to
70˚, 80˚ or 90˚.
• Remove the screw (39A)
• Pull or push the legrest to the desired
angle
• Place the screw in the correct hole and
tighten
max 38 mm
Adjusting the chair