Mellerware 3 5 2 0 02000W - Manual (Page 3)

ADDITIONAL WARNINGS FOR HEATERS:
1.
Read all instructions before using the fan heater.
2. Only connect the fan heater to a single-phase
socket with a main voltage as specified on the
rating plate.
3. This appliance meets the electromagnetic
compatibility requirements specified in EN55104/95
with regard to interferance with radio and TV sets.
4. Do not leave your home while the appliance is in
function, ensure that the switch is in OFF (“O”)
position and that the thermostat is in minimum
position. Always unplug the appliance when not in
use.
5. Keep combustible material such as furniture,
bedding, cushions, clothes, curtains, paper etc. at
least 100cm away from fan heater.
6. If wall mounted do not fix to combustible materials
such as wood, synthetic or plastic surfaces. Do not
hang anything from or in front of the fan heater.
7. Always unplug the heater when not in use. DO NOT
pull the cord to unplug the heater.
8. Keep the air inlet and outlet free from objects at
least 1m in front and 50cm behind the heater.
9. DO NOT use the heater below an electric socket.
10. DO NOT let children or animal play with the
heater. Pay attention! The air outlet gets hot during
operation (more than 80°C)
11. DO NOT COVER. If covered there is a risk of
overheating.
12. DO NOT use this fan heater in the immediate
surroundings of a bath, shower or swimming pool.
13. DO NOT use the heater in room with explosive gas
or while using inflammable solvents, varnish or
glue.
14. Keep the fan heater clean. DO NOT allow any
objects to enter the ventilation or exhaust openings
as this may cause electric shock, or fire or damage
to the heater.
15. Always use the heater in an upright position.
16. DO NOT use the heater to dry laundry.
17. NEVER obstruct the intake and outlet grilles
(danger of overheating).
18. The heater must be at least 50cm from furniture and
other objects.
19. DO NOT use the appliance in room with less than
4m² floor area.
The heater is fitted with a safety device which will switch
off the heater in case of accidental overheating (eg:
obstruction of intake/outlet grilles, motor turning slowly
or not at all).To reset, disconnect the plug from the power
for a few minutes, remove the cause of overheating and
plug the appliance in again.
INSTRUCTIONS FOR USE:
This appliance requires no installation and should be
used solely as a portable appliance.
•
Summer Service (ventillation only): turn the knob to
fan setting.
1 Turn the thermostat knob (left) in a clockwise
direction until it reaches the maximum setting.
2 Heating at reduced power: turn the right knob to
setting I (1000w).
3 Heating at full power: turn the right knob to setting II
(2000w).
4 Switching off: turn the left knob to setting “O”.
REGULATING THE THERMOSTAT:
•
When the room has reached the desired
temperature turn the left thermostat knob in an
anti-clockwise direction up to the point where the
appliance switches off and not beyond.
• The temperature is fixed in this way and will be
automatically regulated and kept at a constant level
by the thermostat.
CLEANING AND MAINTENANCE:
•
Before cleaning always remove the plug from
electrical socket.
• Clean the air inlet/outlet grilles frequently.
• Never use abrasive powders or solvents.
1 2
3 4