MITSUBISHI ELECTRIC WD-57732 User Manual
Page 78
78
Chapter 6. NetCommand Functions
NetCommand-Controlled Devices
and the Input Selection Menu
For devices under NetCommand control, the Input Selec-
tion menu allows you to:
• Select the device for viewing
• Switch audio between the TV speakers and A/V
receiver
• Power compatible devices on or off
• Verify the destination of signals.
Connection
Section
Input
Section
Audio
Section
Figure 1. The Input selection menu for a NetCommand-
controlled device.
Input Section
Press to highlight an input icon and press
ENTER
to select the input to view and hear. “Learned” inputs on a
compatible A/V receiver are automatically changed at the
same time.
Connection Section
The Connection section shows if there is a recording in
progress and the device that is recording from the source.
For example, if the Digital VCR (D-VCR) is currently
recording from
ANT 1, when you move the highlight to
the Ant-1 icon, the D-VCR icon appears in the Connection
Section. This icon disappears when you move the high-
light to another icon or press
CANCEL to stop recording.
Audio Section
A NetCommand-controlled A/V receiver connected to the
TV appears as an
AVR icon in the Audio section. Press
AUDIO to change navigation to the Audio section. Then
press to select either the TV speakers icon or the A/V
receiver icon. Press
ENTER to change the audio selection.
Press
INPUT to return navigation to the Input section.
The Remote Control and NetCommand
Point the TV’s remote control at the TV when operat-
ing NetCommand-controlled devices. See the chart in
chapter 3, “TV Setup,” to review device functions you can
“learn” for the device. Further information on some func-
tions is included here.
The Input Selection Menu and NetCommand
Power Devices On/Off
First “learn” the power key(s) for the device. Press
INPUT
to display the Input Selection menu. If you press
POWER
without first displaying the Input Selection menu, the TV
will turn off.
•
Devices with separate ON and OFF remote control
keys. These devices power on automatically when
you select the device in the Input Selection menu and
will power off when you turn off the TV.
•
Devices that do not power on or off automatically.
To power on: Highlight the device icon in the Input
Selection menu and press
POWER. Press ENTER to select
the device.
To power off: Press
INPUT to open the Input Selection
menu and highlight the device icon. Press
POWER on
the TV’s remote control.
•
A/V receiver. Open the Input Selection menu and
press
AUDIO to move navigation to the Audio section.
Highlight the A/V receiver icon and press
POWER on the
TV’s remote control.
Additional Functions
Highlight the device icon in the Input Selection menu
and press
ENTER to select the device. Re-open the Input
Selection menu and press the “learned” key indicated in
the table below.
“Learned” Key for the Device Action
MENU
Close Split Screen before-
hand, if active. Press
MENU
to open the device’s menu.
Use to navigate
the menu.
GUIDE (“Learned” to change
VCR inputs)
Press
GUIDE repeatedly to
cycle through the VCR’s
inputs.
IMPORTANT
If a device does not respond to separate ON
or OFF signals from the remote control, the
manufacturer has not provided that capabil-
ity for the device.