Maytag DC68-01052A User Manual

Maytag Washers

Advertising
background image

5.

2.

6.

1.

S TAC K ING K IT INS TAL L ATION

1)P osition the unit on a level surface,

capable of supporting the entire

weight of the dryer.

R emember that the unit will be

heavier when it is fully loaded.

C lean the surface where the stacking

kit is going to be installed.

P lace the mounting bracket on the

Washer as indicated.

2) R emove the 2 plastic covers (shown in figure 6) attached

to the middle of the stacking kit, and save these for

later use. R emove the double back tape and firmly attach

the stacking kit the top of the washer to assure the

proper seal.

Make sure the word F R ONT printed on the stacking kit

is facing forward as shown above.

3) P ut back edge of stacking kit to back mold line of washer

5) Y our Dryer is equipped with 4 leveling legs.

Make sure they are lowered 10 mm, so there is a

gap between the legs and the dryer base.

6) G ently push the dryer into position as

indicated in figure 5 & 6, sliding the unit into

the slots provided.

It is important that the dryer is level.

Make sure all four leveling legs are pushed

all the way back into the slots to ensure

proper mounting.

3.

6.

4) Install all 7 screws provided with a power drill

and tighten the stacking kit to the unit base securely.

4.

8.

DC 68-01052A

7) Insert the plastic covers

(removed in section 2)

covering the two front

slots of the leveling legs.

Depending upon the

location of the unit, it may

be necessary to change

the side on which the dryer

door opens.

7.

( back )

Advertising
This manual is related to the following products: