Mellerware AMBIENTE 3 5 5 5 02200W - Manual (Page 3)

• Always unplug the heater when not in use.
• Do not operate any heater with a damaged cord
or plug, or after the heater malfunctions, has been
dropped or is damaged in any manner. Return
the heater to an authorized service facility for
examination.
• Do not use the heaters outdoors.
• This heater is not intended for use in bathrooms,
laundry areas or similar moist indoor locations.
Never locate the heater where it may fall into a
bathtub or other water containers.
• Do not use this heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
• Do not run the power cord under carpeting or
cover the cord with throw rugs, runners or the
like. Arrange the cord away from traffic areas and
where it will not be tripped over.
• Do not place the cord over any part of the heater.
• Do not plug this heater into an extension lead,
double adapter or power board.
• Do not operate unless the cord is fully unreeled.
• Do not attempt to repair, disassemble or modify
the appliance. There are no user-serviceable parts,
and this will void the 2 year guarantee.
• To disconnect the heater, set controls to OFF then
remove the plug from the outlet.
• To prevent a possible fire, do not block air intakes
or exhausts in any manner.
• Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause
an electric shock, fire or could damage the heater.
• This heater has hot electrical parts inside. DO NOT
use it in areas where gasoline, paint or flammable
liquids are used or stored.
• Use the heater only as described in this booklet.
Any other use is not recommended by the
manufacturer which may cause fire, electric shock
or injury to persons.
• Fully remove the power cord from the cord storage
before use. Always uncoil the power cord before
applying power.
• This product must always be used AND STORED
in the upright position.
Warning: in order to avoid overheating, do not cover
the heater.
COMPULSORY WARNING
If the supply cord is damaged, the cord must be
replaced by the manufacturer. This Column Heater
is filled with a precise quantity of oil. Repairs requiring
the opening of the oil container are only to be
conducted by the manufacturer or a qualified authorized
service agent who should be contacted if there is an oil
leakage.
Disposal of the oil should be in accordance with local
regulations. You should contact your local council to
determine the correct procedure.
This product has not been designed for any uses other
than those specified in this booklet.
SAVE THESE INSTRUCTIONS
YOUR HEATER COLUMN
Before first using your new appliance, it is most
important that you read and follow the instruction in this
use and care booklet, even if you feel you are quite
familiar with this type of appliance.
Your attention is drawn particularly to the section dealing
with “IMPORTANT SAFEGUARDS”. Find a place and
keep this booklet handy for future reference.
Your Column Heater is easy and safe to use. It has been
designed to function quietly and safely under normal
circumstances. Read all instructions to ensure safe and
efficient use.
HEATING
The columns or fins are filled with a special oil that
conducts heat to the metal surfaces. These in turn warm
the air around them which gently and silently heats
the room. Be careful because they work under pressure
as the oil inside heats up. Like any electrical appliance,
this product may cause injury or damage property if
used whilst damaged.
MOUNTING THE FEET
1. Place the column heater upside-down on a
scratch-free location, make sure it is stable and will
not fall.
2. First snap the cord holder onto the front foot.
(Note: the oval concave should be upwards.)
3. Snap the front foot onto the front cover and then
use two short screws provided to fix the front foot
in place.
4. Snap the back foot onto the back cover and then
use two long screws provided to fix the back foot
into place.
NOTE: After wheels assembled as to above, take the
unit in upright position, if you find unit is not stable on
the ground, you can adjust the two screws on back
wheels.
WARNING:
Do not operate without feet attached. Operate the heater
only in an upright position (feet on the bottom, controls
on the top), any other position could create a hazardous
situation.
NOTE: After attaching the feet wait at least 15 minutes
for the oil in each fin to setting before using the column
heater.