Motion Computing M1400 - Manual (Page 23)

Chapter
2 Motion Tablet PC Hardware
Motion Computing M1400 Tablet PC User Guide 15
F INGERPRINT
R EADER
The built-in fingerprint reader lets you scan your
fingerprint and associate it with a password. This
offers a quick and convenient way to log on to
your Tablet PC, provides global password
management, and protects your Tablet PC data
from unauthorized access.
A MBIENT L IGHT
S ENSOR (ALS)
A built-in light sensor located on the Tablet PC
front panel measures the ambient light in the
environment. The system then automatically
balances the brightness of the Tablet PC display
in relation to the surroundings. You can set two
brightness modes from the Motion Dashboard:
• Fixed — Sets the display brightness to a
fixed level (ALS is off)
• Dynamic — Sets the display so that the system adjusts the brightness to
the preferred level under changing lighting conditions while maintaining
viewability (ALS is on)
For optimal power management benefits, set the brightness slider to the mid-
point or slightly above or below mid-point.
S PEAK
A NYWHERE
T ECHNOLOGY
The Motion Speak Anywhere TM technology consists of configuration and
array acoustics software that supports three microphone settings on the
Motion Dashboard:
• Narrow Angle — For single-person dictation
• Medium Angle — For a small meeting with several people
• Wide Angle — For a large meeting; disables all “Array Processing” or
“beam-focusing” software (defined below)
The configuration software helps optimize the sound capabilities of your
Tablet PC for voice recognition and Voice over IP (VoIP) by providing these
benefits:
• Array Processing or “beam focusing” software — Removes all sound
outside the angle of acceptance
• Noise Suppression — Removes background and ambient noise
• Acoustic Echo Cancellation (AEC) — Removes echo caused by micro-
phone detection of the system’s speaker output and prevents feedback
NOTE: For more information, see Chapter 4 of this User Guide.
PC C ARD S LOT The PC Card slot, located on the button edge of the Tablet PC, holds one
Type-II PC Card for networking, memory expansion, or accessory
connection.
1. To install a PC Card, insert it label side up.