Minicom Advanced Systems DX System - Manual (Page 27)

USER GUIDE
26
11.1.1 General information about Auto detect
Each device auto-detected receives a default name e.g. 1Server01.
All devices have the default timeout period of 60 seconds. When a server is
accessed, after 60 seconds of inaction another user may take control of the server or
the present user can regain control by moving the mouse or typing on the keyboard.
You can change this timeout period.
All devices have the default keyboard mode set to PS/2 for Intel based computers.
You must change this setting for other device types.
To change any of the above parameters for a device:
1. Click the devices output port on the picture of the switch. The General tab of the
Computer Port Configuration box appears, see Figure 46.
Figure 26 Computer Port Configuration box
The General tab elements
Name – Type a name for the connected device, e.g. Fax server. This name appears
below the device in the Servers window.
Type – With Autodetect the appropriate XRICC type connected to the port appears
here.
Note!
With an XRICC RS232 type, a Terminal button appears. See Figure 27. Click the
button. Terminal settings appear. Input the correct terminal settings according to the
device parameters you wish to connect to. Click the Terminal button to close the
Terminal settings.