Software support, Firmware monitor, Operating systems and kernels – Motorola MVME5100 Series User Manual
Page 3: Specifications, Mvme5100 processor module, Processor, Main memory, Flash memory, Nvram, Counters/timers
face signals to the MVME712M transition module. The 3-row
P2 adapter can be used for 8-bit SCSI.
To gain access to the additional user definable I/O pins pro-
vided via the 5-row VME64 extension connector, a special P2
adapter board is available. This adapter panel replaces the
traditional 3-row P2 adapter and extends its capability by pro-
viding access to the PMC I/O pins.
S o f t w a r e S u p p o r t
Firmware Monitor
Firmware must fulfill the traditional functions of test and initial-
ization and provide operating system boot support. The
MVME5100 firmware monitor exceeds these requirements
with a proven monitor from the embedded VME leader. It
expands features like power-up tests with extensive diagnos-
tics, as well as a powerful evaluation and debug tool for sim-
ple checkout or when high-level development debuggers
require additional support. All this is included with the
MVME5100 firmware; plus it supports booting both operating
systems and kernels.
Operating Systems and Kernels
MVME5100 supports booting a variety of operating systems
including a complete range of real-time operating systems
and kernels which may be purchased from the following com-
panies:
S p e c i f i c a t i o n s
M V M E 5 1 0 0 P r o c e s s o r M o d u l e
Processor
Main Memory
Flash Memory
NVRAM
Counters/Timers
VMEbus ANSI/VITA 1-1994 VME64 (IEEE STD 1014)
Ethernet Interface
Asynchronous Serial Ports
Dual IEEE P1386.1 PCI Mezzanine Card Slots
Wind River Systems, Inc.:
VxWorks
®
Multiple Partners:
Linux
®
Microprocessor:
MPC7400
MPC750
Clock Frequency:
400 MHz
450 MHz
On-chip Cache (I/D):
32K/32K
32K/32K
Secondary Cache:
1MB or 2MB
1MB
Type:
PC100 ECC SDRAM with 100 MHz bus
Capacity:
64MB, 128MB, or 512MB on board,
expandable to 1GB with RAM500 mem-
ory mezzanines
Single Cycle Accesses:
10 Read/5 Write
Read Burst Mode:
7-1-1-1 idle; 2-1-1-1 aligned page hit
Write Burst Mode:
4-1-1-1 idle; 2-1-1-1 aligned page hit
Architecture:
64-bit, single interleave
Type:
EEPROM, on-board programmable
Capacity:
1MB via two 32-pin PLCC/CLCC sockets;
16MB surface mount
Read Access (16MB
port):
70 clocks (32-byte burst)
Read Access (1MB
port):
262 clocks (32-byte burst)
Capacity:
32KB (4KB available for users)
Cell Storage Life:
50 years at 55° C
Cell Capacity Life:
5 years at 100% duty cycle, 25° C
Removable Battery:
Yes
TOD Clock Device:
M48T37V
Real-Time Timers/
Counters:
Four, 32-bit programmable
Watchdog Timer:
Time-out generates reset
Controller:
Tundra Universe
DTB Master:
A16–A32; D08–D64, BLT
DTB Slave:
A24–A32; D08–D64, BLT, UAT
Arbiter:
RR/PRI
Interrupt Handler/
Generator:
IRQ 1–7/Any one of seven IRQs
System Controller:
Yes, jumperable or auto detect
Location Monitor:
Two, LMA32
Controller:
Two Intel 82559ER
Interface Speed:
10/100Mb/s
PCI Local bus DMA:
Yes, with PCI burst
Connector:
One routed to front panel RJ-45, one
routed to front panel RJ-45 or optionally
routed to P2, RJ-45 on MVME761
Controller:
16C550C UART
Number of Ports:
Two, 16550 compatible
Configuration:
EIA-574 DTE
Async Baud Rate, bps
max.:
38.4K EIA-232, 115Kbps raw
Connector:
One routed to front panel RJ-45, one on
planar for development use
Address/Data:
A32/D32/D64, PMC PN1, PN2, PN3,
PN4 connectors
PCI Bus Clock:
33 MHz
Signaling:
5V
Power:
+3.3V, +5V,
±
12V; 7.5 watts maximum
per PMC slot
Module Types:
Two single-wide or one double-wide, front
panel or P2 I/O