Miele KM5773 - Manual (Page 19)

Touch controls
The control panel is equipped with
electronic sensors. They respond to a
finger touch.
To operate the burners, simply touch
the corresponding sensor area(s). Each
time a command is registered, a signal
will be heard.
Be sure to touch only the desired
sensor area and keep the control
panel clean and clear. Otherwise,
the touch controls may not respond,
or unintentional commands may be
given, even causing the cooktop to
switch off automatically (see the
section on "Safety cut-out feature").
NEVER place hot cookware on the
sensor areas. The electronics can
be damaged.
Turning on the cooktop
^ Put a pot or pan on the desired
burner.
^ Touch the ON/OFF "s" cooktop
touch control.
You will see a dash
- in each of the
burner displays, and
00 in the timer
display. If a setting is not chosen within
a few seconds the cooktop will turn off
as a safety measure.
Turning on a burner
^ Touch the s On/Off touch control for
the desired burner.
The respective burner display shows
0.
^ Select a power level between 1 and
12 by pressing the - or + sensor.
When turning on the cooktop you can
decide whether you want to cook with
auto heat or not. See "Auto-heat" for
more information.
Turn on with + to:
cook without auto-heat.
Turn on with – to:
cook with auto-heat.
Use
19