Mellerware TURBO GLIDE 2 3 4 5 02 0 0 0 W - Manual (Page 4)

- Stand the iron upright and press the plug it in.
- Turn the temperature gauge to the ***position.
- Let the iron heat up until the pilot light goes off
and comes back on again.
- Unplug the iron and place it over the sink.
- Push the self-cleaning button (D) and keep it
pushed down.
- Let the water flow out through the steam vents in
the base, while lightly shaking the iron.
- Release the self-cleaning button after a moment
or when the tank has emptied and place the iron in
an upright position.
- Let the iron cool and then clean it.
Anomalies and repair
Go to an authorized Technical Support Service in
the event of malfunctions. Do not try to dismantle or
repair the iron yourself, as this may be dangerous.
If the connection to the mains has been damaged,
it must be replaced, and you should proceed as
you would in the case of damage.
Ecology and recyclability of the product
- The materials of which the packaging of this ap-
pliance consists are included in a collection, clas-
sification and recycling system. Should you wish to
dispose of them, use the appropriate public con-
tainers for each type of material.
- The product does not contain concentrations of
substances which could be considered harmful to
the environment.
- Should you wish to dispose of the product once
its working life has ended, take it to an authorised
waste agent for the selective collection of waste
from electric and electronic appliances.
MW_CO23450_TURBOGLIDE_STEAM_IRON_IM.indd 4 MW_CO23450_TURBOGLIDE_STEAM_IRON_IM.indd 4 7/14/2009 3:38:16 PM 7/14/2009 3:38:16 PM