M-AUDIO RAD-050503 - Manual (Page 18)

represents the controller’s function or the Controller #, the DATA ENTRY slider
will immediately function to select the transmitted value of that specific controller
when the slider is moved.This can be very useful for manipulating various functions
during actual performance, mixing or recording, etc..
Assignable Sliders and Knobs
The Radium keyboard comes with 9 banks of factory presets. These presets
work well with a variety of MIDI devices.The default assignments for the sliders
and knobs which load when the Radium is powered on have been selected in
order to work well with General MIDI instruments. They are listed in the
following table.
*
Preset # Channel # Contoller # Definition Application
(Sliders:)
1
1 82 Attack Filter
2 1 83 Decay “
3 1 28 Sustain “
4 1 29 Release “
5 1 81 Filter Envelope “
6 1 74 Cutoff “
7 1 71 Resonance “
8 1 2 Breath Misc. Controls
(Knobs:)
9
1 5 Glide Time “
10 1 10 Pan “
11 1 21 Pitch, Coarse Oscillator
12 1 77 Pitch, Fine “
13 1 16 Filter Rate LFO
14 1 19 Filter Depth “
15 1 18 Pitch Depth “
16 1 80 Amp. Depth “
*Refer to Appendix B of this manual for the information of the remaining preset banks .
Programming the Sliders and Knobs:
Pressing the MIDI/SELECT button and then the SET CTRL key will allow you to
begin programming the controller sliders and knobs. In order to change the
value of each slider (1 - 8) and knob (9 - 16), do as follows:
1. Press MIDI/SELECT, then the Set Controller key (marked “SET CTRL.)” The
display will show a small “n” to indicate that the desired controller knob
“number” should be entered next.
18