Minolta CF910 - Manual (Page 15)

1-1
Sa
fe
ty No
tes
Chapter 1
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
Power Source
The power source voltage requirements are as follows.
◆ Use a power source with little voltage fluctuation.
Voltage Fluctuation : Within ± 10%
Frequency Fluctuation : Within ± 0.3%
Space Requirements
To ensure easy copier operation, supply replacements and service maintenance, adhere to the
recommended space requirements detailed below.
* Be sure to allow a clearance of 6” or more at the back of the copier as there is a ventilation duct.
◆ A place away from a curtain or the like that may
catch fire and burn easily.
◆ An area where there is no possibility of being
splashed with water or other types of liquid.
◆ An area free from direct sunlight.
◆ A place out of the direct air stream of an air
conditioner, heater, or ventilator.
◆ A well-ventilated place.
◆ A dry place.
◆ A dust-free location.
◆ An area not subject to undue vibration.
◆ A stable and level location.
◆ A place where ammonia or other organic gas is
not generated.
◆ A place which does not put the operator in the
direct stream of exhaust from the copier.
◆ A place which is not near any kind of heating
device.
1154O026AA
Scale: inch
60-3/4
24-1/2 36-1/4
42-3/4
25-1/4
30 20
50-1/4
44
58