Motorola DSR500 - Manual (Page 11)

11
Notes:
Video and audio quality should be best when the DSR is connected directly to the primary
output component, such as the television or monitor (for video), and the television or home
theater A/V receiver (for audio). Use quality cables designed for these applications.
If you are using the component video outputs, you may have to toggle the HDTV mode select
button behind the flip-down door on the front panel. This toggles the HDTV output between
1080i, 480p, 480i, and native modes. Native mode (0000) is the original transmitted signal. You
should leave this on native mode unless your TV or monitor requires a specific mode such as
1080i.
If you are using the RF output tune your TV to channel 3 or 4 to match the position of the
channel 3/4 switch on the back panel of the satellite receiver.
Home theater A/V receivers can provide a method to connect multiple input sources if your
television does not have enough input connectors. Some home theater A/V receivers may also
provide very good or enhanced quality. Refer to your home theater A/V receiver instructions for
further information.
Optical
Audio
Y
P R
P B
HD
Compatible
TV
STEREO