MITSUBISHI ELECTRIC MC 200 - Manual (Page 25)

21 MAN-PNLPC-001 MC200 Series Industrial Panel Computers
7 MAINTENANCE AND UPGRADES
4. Remove the “card retaining bracket” from center posts by removing
screw from back post holding card retainer. Lift up retainer and slide
out of the slot in the front post.
CARD RETAINING
BRACKET SHOWN
INSTALLED
FRONT
Center Post
End of bracket
inserted through
slot in Front Center
Post
SIDE VIEW
BACK
Center Post
5. Insert the expansion card into the backplane connector and reinstall
the screw to secure the card’s end plate to the enclosure.
Expansion Card seated
in backplane connector
Reinstall cover screw
here to secure card end
plate to enclosure
Screw securing bracket
to Back Center Post
(screw is on other side of
post)
Back Front