Memorex MM1740 User Manual
Page 7
7
ERROR MESSAGE AND POSSIBLE SOLUTION
CABLE NOT CONNECTED :
1.Check that the signal-cable is properly connected , If the connector is loose, tighten the
connector’s screws.
2.Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT:
Your computer has been set to unsuitable display mode, Set the computer to display mode
given in the following table.
UNSUPPORTED MODE TRY DIFFERENT VIDEO CARD SETTING:
Your computer resolution is out of VESA-SPEC
RESOLUTION:
RESOLUTION
VERTICAL
FREQUENCY
RESOLUTION
VERTICAL
FREQUENCY
640×480
60Hz
800×600
75Hz
720×400
70Hz
1024×768
60Hz
640×480
72.8Hz
1024×768
70Hz
640×480
75Hz
1024×768
75Hz
800×600
56.3Hz
1024×768
74.92Hz
800×600
60.3Hz
1280×1024
60Hz
800×600
72.2Hz
1280×1024
75Hz
APPENDIX
SPECIFICATIONS
Driving system
TFT Color LCD
Size
43cm(17”)
Pixel pitch
0.264mm(H)×0.264MM(V)
Viewable angle
140° (H)130° (V)
LCD Panel
Response time
16ms
Video
R,G,B Analog Interface
Separate Sync.
H/V TTL
H-Frequency
30kHz-80kHz
V-Freauency
55-75Hz
Input
DVI
DIGITALIN
Display Colors
16M Colors
Brightness
300cd/m
2
Contrast
450;1
Max. Resolution
1280×1024
Plug & Play
VESA DDC1/2B
TM
Input Connector
D-Sub 15pin
Input Video Signal
Analog:0.7Vp -p(standard), 75OHM,Positive
Maximum Screen Size
Horizontal:380.16mm Vertical:304.1mm
Power Source
100~240V AC,50~60Hz
Environmental Considerations
Operating Temp:0° C to 40° C Storage Temp:-20
° C to 60° C Operating Humidity:10% to 85%.
Weight (N.W.)
4.2kg