Murray 309007x8B - Manual (Page 11)

ASSEMBLY
11 F−050611L
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
(B)
17x47
1. Carefully remove the plastic bag from the seat.
2. Raise the seat support and secure in the UP position with the
seat support rod.
3. Align the holes in the seat to the holes in the seat support
(Figure 1). Fasten the seat to the seat support with the fasten-
ers as shown.
4. Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts (A). Slide the seat for-
ward or backward along the seat adjusting holes as shown.
Tighten the wing bolts (A).
Figure 1
Seat
Seat
Adjusting Hole
Seat Support
A
B
Seat Support Rod
HOW TO ASSEMBLE THE STEERING WHEEL
Attach the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Slide the tube into the console (Figure 2). Make sure the end
of the tube fits over the steering bushing.
NOTE: Before attachment of the steering wheel, make sure
that the front wheels point forward and are straight. The
steering wheel will have either 3-spokes or 4-spokes. For
proper alignment of the steering wheel, see Figure 2.
3. Slide the steering wheel and steering post into the tube and
console. Push on the steering wheel. The steering post will
lock onto the pinion gear. Pull on the steering wheel. Make
sure that the steering post is locked in place.
Steering Wheel
Tube
Figure 2
Steering Post
Console
Straight