Miele ESW 50X0-29 - Manual (Page 31)

~
Before connecting the appliance to the mains supply
make sure that the connection data on the data plate (voltage
and connected load) correspond with the mains electricity
supply, otherwise the appliance could be damaged. Consult
a qualified electrician if in any doubt.
~
The socket and on-off switch should be easily accessible
after the appliance has been built in.
~
The food warming drawer may only be built in in
combination with those appliances quoted by the
manufacturer as being suitable. The manufacturer cannot
guarantee trouble-free operation if the appliance is operated
in combination with appliances other than those quoted by
the manufacturer as being suitable.
~
When building in the food warming drawer in combination
with another suitable appliance, the food warming drawer
must be fitted above a fixed interim shelf in the housing unit
to ensure that the housing unit can suport both its weight and
that of the other appliance.
~
As the combination appliance is placed directly on top of
the food warming drawer once it is built in, an interim shelf is
not necessary between the two appliances.
~
The appliance must be built in so that the contents of the
drawer can be seen. This is to avoid scalding from hot food
spilling over. There must be enough space for the drawer to
be pulled out fully.
~
This appliance may only be installed in mobile installations
such as ships, caravans, aircraft etc. if a risk assessment of
the installation has been carried out by a suitably qualified
engineer.
~
The food warming drawer is available in two models,
which differ in height. The building-in dimensions for the food
warming drawer must be added to the building-in dimensions
for the combination appliance to establish the niche size
required.
All dimensions in this instruction booklet are given in mm.
Safety instructions for installation
31