Miele ESW 50X0-29 - Manual (Page 39)

After building in the combination appliance, it may be
necessary under certain circumstances to
– align the front of the food warming drawer.
– align the gap between the food warming drawer and the
combination appliance.
^ Remove screws a from the left and right side of the drawer
front.
^ Carefully lift the control panel out, taking care not to
damage or pull on the cable, and place it on the floor of the
drawer.
^ Loosen the 2 screws b on the inside of the drawer front.
^ Align the drawer front.
^ Tighten the screws on the inside of the drawer front.
^ Carefully replace the control panel, taking care not to
damage or pull on the cable.
^ Replace the 2 screws in the left and right side of the drawer
front.
Aligning the front of the food warming drawer
39