Marantz STRIKER S160 - Manual (Page 8)

8
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Heatshield
Mounting
Holes
Air Channel
Front
Figure 2
Figure 1
o
uTsiDe
a
ir
k
iT
i
nsTallaTion
To install the “Outside Air Kit,” position the clip so that the
nut is directly above the hole punched in the back of the
heatshield (See Figure 3). Install the outside air adapter
box on the stove by sliding it into the air channel located
between the bottom heatshield and the stove bottom until
the oblong ring is approximately 1/4” from the rear edge
of the lower heatshield. Make sure the ring is facing down.
Thread the 1/4” bolt up through the nut in the clip until snug
against the adapter box.
To locate the hole in the hearth for outside air, mark a 4”
circle on the hearth. The circle’s center should be 2-3/4”
directly back from the center of the flue outlet and 5/8” to
the left side.
Figure 3
Expanded View of Clip
l
eg anD
h
eaTshielD
i
nsTallaTion
Note: The threaded rods used to bolt the legs to the stove
are packaged with the heatshield, as a heatshield is required
when a stove is installed on legs.
Residential and Mobile Homes
(Bolting down and grounding of stove are required only
in mobile homes).
Open all cartons, if any, and remove the contents upon re-
ceipt and check for any damaged or missing parts. If there
is hidden damage, notify your freight company or Lennox
Hearth Products dealer immediately.
Leg Installation
1. Carefully place stove on its back. Be careful not to
scratch the stove, use a piece of cardboard or carpet
to protect the back of the stove.
2. Mount all four legs as shown in Figure 1 below.
3. First, screw the threaded rods into the holes at the
four corners on the bottom of the stove. Screw the
threaded rods into the firebox three full rotations or
3/16 to 1/4” (if the rear rods are screwed in too far
they will lift the bricks off the bottom of the stove).
Use a washer and nut to secure the leg. Be sure the
legs are mounted squarely on the firebox bottom.
Tighten nuts securely.
4. Use the two bolts and washers provided with the
heatshield kit to mount the heatshield as shown in
Figure 2 below.
5. Do not over tighten the heatshield mounting bolts as
it may bend the heatshield.
Line up the hole in the clip with the hole in
the rear center of the bottom heatshield