MK Sound V-1250THX - Manual (Page 11)

V-1250THX subwoofer page 11
FIGURE 6 - WIRING TWO SUBWOOFERS TO AN AMP
OR PREAMP WITH ONE SET OF PREAMP OUTPUTS
1 0 3 9 1 J e f f e r s o n B l v d , C u l v e r C i t y , C A 9 0 2 3 2 3 1 0 / 2 0 4 - 2 8 5 4
M I L L E R & K R E I S E L S O U N D C O R P O R A T I O N
Made in U.S.A.
T 4 AMP 120 VAC 50/60 Hz
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE
DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC
ELECTRIQUE. NE PAS OUVRIR .
Manufactured under license
from Lucasfilm Ltd.
Lucasfilm and THX are registered trademarks
of Lucasfilm Ltd.
use one Y-connector
for each channel
to split the output
of the preamp
RIGHT LEFT PREAMP
MAIN OUT
POWER AMP
RIGHT LEFT
MAIN IN
RIGHT LEFT/MONO
INPUT
REFERENCE
80 Hz
24 dB/OCTAVE
THX
VARIABLE +
–
PHASE THX
LOW PASS
FILTER
+3 dB
+6 dB
BASS LEVEL
RIGHT LEFT/MONO
INPUT
REFERENCE
80 Hz
24 dB/OCTAVE
THX
VARIABLE +
–
PHASE THX
LOW PASS
FILTER
+3 dB
+6 dB
BASS LEVEL
1 0 3 9 1 J e f f e r s o n B l v d , C u l v e r C i t y , C A 9 0 2 3 2 3 1 0 / 2 0 4 - 2 8 5 4
M I L L E R & K R E I S E L S O U N D C O R P O R A T I O N
Made in U.S.A.
T 4 AMP 120 VAC 50/60 Hz
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE
DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC
ELECTRIQUE. NE PAS OUVRIR .
Manufactured under license
from Lucasfilm Ltd.
Lucasfilm and THX are registered trademarks
of Lucasfilm Ltd.
If you have two subwoofers, it is not necessary to use both inputs on each subwoofer. Connect the
interconnect cable to one "FROM PREAMP" jack only. Run the Left channel interconnect cable to the
Left subwoofer and the Right interconnect cable to the Right subwoofer. See Figures 4 and 6.
WIRING WITH THE M&K HP-80 OR VF-80 HIGH-PASS FILTERS (NON-THX)
The M&K HP-80 and VF-80 High-Pass Filters can improve any system that allows its preamp and
power amp stages to be separated, by filtering the bass fed to the main amp and Satellite speakers.
These filters will give your system greater dynamic range, lower distortion, and an increased
maximum output. To use these filters with an integrated amp or receiver, the amp or receiver MUST
have back panel RCA jacks labelled PREAMP/MAIN OUTPUT and POWER AMP/MAIN INPUT.
There may be a switch or jumper connections between them, which you will have to remove. If you
have any questions about your components, contact your dealer or M&K.
For non-THX systems, your subwoofer is optimized for use with the HP-80 High-Pass Filter.
We strongly recommend that you use this filter with any component system that allows for its use.
When you use this subwoofer with an HP-80 and M&K Satellites, the combination forms a 4th order
Linkwitz-Riley crossover between satellite and subwoofer. The linear phase of this crossover means
uncompromised performance with great flexibility in system setup, without requiring elaborate
calibrations or adjustments.
Do not use either of these filters with a THX controller. The THX controller has the appropriate filters
in its built-in crossover circuitry. Also, do not use a SUBWOOFER OUTPUT jack on your amp or
processor to feed any of these filters.
To connect one of these filters, run one set of shielded RCA - RCA interconnect cables from the