Morphy Richards Soprano kettle - Manual (Page 4)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Using
1 Remove the lid and fill the kettle.
The integrated water level gauge/
viewing lid allows you to easily see the
amount of water in this kettle.
• Always put enough water to cover the
bottom of the kettle, minimum 1 cup
200cc.
• Boil only as much water as you need
as this saves electricity.
2 Place the kettle on the base unit,
ensuring the kettle locates on to the
360
o connector.
• The 360 o connector allows the kettle
to be located at any position - ideal for
left and right handed users and
convenient positioning on your
worktop.
3 Plug in and switch on at the wall
socket.
4 Switch the kettle on. The ‘power on’
indicator neon on top of the handle
will light up.
5 When the water boils, the kettle will
switch off automatically and the
whistle will sound, to indicate that the
water has boiled and has switched off
automatically.
• The whistle can be switched off for
silent operation. The switch is on the
underside of the base unit.
• If you are using the kettle for the first
time, pour away the boiled water and
refill.
6 When lifting the kettle from the base
unit by the handle ensure you hold
the kettle level.
• To reboil, switch to ON again. if the
kettle has just switched off wait
several seconds or so before
switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty,
the safety cut-out will switch off the
power automatically. If this happens,
wait a few minutes for the element to
cool, then refill and use as normal.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Filter removal
1 Open the lid.
2 Lift the filter upwards from its location
using the tab provided. Note which
way you have removed the filter and
replace the same way after cleaning.
3 To refit the filter, slot it into the guides
and press down firmly until it clicks
into place. Ensure the filter is correctly
located into the central guide.
Note: Which way you have removed
the filter and replace the same way
after cleaning.
WARNING: Unless the filter is fitted
correctly, the kettle lid may not close
and lock securely.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Cleaning the filter
1 To clean the filter run warm water over
the mesh and scrub lightly to remove
the soft deposits with a suitable brush.
A toothbrush would be ideal.
2 If the soft lime deposits have become
hard, the filter will need descaling, see
descaling page 5.
4