MTD E614E - Manual (Page 5)

5
SECTION 4: CONTENTS OF HARDWARE PACK
A
ATTACHING THE HANDLE ASSEMBLY
Lay out the hardware according to the illustration for identification purposes. Parts are illustrated approximately
one-half size. Part numbers are shown in parentheses. (Hardware pack may contain extra items which are not
used on your unit.)
B
ATTACHING THE CHUTE ASSEMBLY
C
ATTACHING THE CHUTE CRANK
D ATTACHING THE SHIFT ROD
AND CLUTCH CABLES
F
AUGER SHEAR BOLTS
Ferrule
(711-0677)
Hairpin Clips
(714-0104)
Jam Nuts
#10-24 Thread
(712-0121)
“Z”-Fitting (R)
(746-0778)
The augers are secured to the spiral shaft with two shear bolts
and hex lock nuts. If you hit a foreign object or ice jam, the snow
thrower is designed so that the bolts will shear. Two replace-
ment shear bolts and nuts are provided for your convenience.
Store in a safe place until needed.
E
ATTACHING THE CLUTCH GRIPS
Flat Washers
5/16" I.D. x 5/8" O.D.
(736-0264)
Hex Bolts
5/16-18 x 1-3/4" Long
(710-3180)
Hex Bolts
5/16-18 x 3/4" Long
(710-3008)
Hex Nuts
5/16-18 Thread
(712-3010)
Saddle
(784-5599)
Lock Washers
5/16" I.D.
(736-0119)
Carriage Bolts
5/16-18 x 1-1/2" Long
(710-0262)
Hex Bolts
1/4-20 x 3/4" Long
(710-3015)
Hex Lock Nuts
1/4-20 Thread
(712-3027)
Chute Flange
Keepers
(731-0851A)
Hairpin Clip
(714-0104)
Flat Washers
3/8" I.D. x 5/8" O.D.
(736-0185)
Hex Nut
5/16-18 Thread
(712-3010)
Lock Washer
5/16" I.D.
(736-0119)
Hex Bolt
5/16-18 x 1-1/2"
Long
(710-0442)
Hex Lock Nuts
5/16-18 Thread
(712-0429)
Shear Bolts
5/16-18 x
1-1/2" Long
(710-0890A)
Hex Screw 5/16-18
x 2.0 (710-0116)
Hex Top L-Nut
5/16-18 (712-0429)
Spacer
.325 I.D. x .50 O.D. x .25
(750-1032)