Miele ESW 408X-14 - Manual (Page 24)

~
Before installation make sure that
the voltage and frequency listed on the
data plate correspond with the
household electrical supply. This data
must correspond in order to avoid risk
of damage to the appliance. If in doubt,
consult a qualified technician.
~
The electrical outlet should be easily
accessible after installing the unit.
~
Be sure that after installation the
power cord does not come into contact
with any hot surfaces.
~
The food warming drawer must be
installed so the contents of the drawer
can be seen. Otherwise spills could
cause burns or scalding.
Be sure there is enough space for the
drawer to be pulled out completely.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
ESW 408x-14
~
Only install the warming drawer in
combination with built-in appliances
recommended by the manufacturer.
When installed with other appliances,
the warranty is void since the
manufacturer cannot guarantee the
safe use of the plate warmer.
~
To install the warming drawer in
combination with another appliance, a
built-in shelf must exist in the cabinet to
support the weight of both appliances.
~
When installed in combination with
another appliance, the warming drawer
must always be installed beneath the
other appliance. The combination
appliance can be set without a base
directly onto the plate warmer. A shelf
between the appliances is not
necessary.
~
The building in dimensions of the
warming drawer must be added to the
building in dimensions of the
combination appliance to determine the
niche size required.
Note to the installer:
Please leave these instructions with the
consumer of the appliance for the local
building inspectors use.
SAVE THESE
INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
24