Philips Magnavox 25i - Manual (Page 12)

12
H
OW TO
A
UTOMATICALLY
P
ROGRAM
TV C
HANNELS
Tuner Mode
Antenna
Auto Program
3
Auto Program
7
1 2 3
4 5 6
7 8 9
0 A/CH
POWER
CC
STATUS
EXIT
SLEEP MUTE
MENU
CH+
CH–
VOL+
VOL–
Brightness
+ –
Install
Language
English
1
4
2
6
2
4
5
3
Y our TV can automatically set itself
for local area (or Cable TV) chan-
nels. This makes it easy for you to
select only the TV stations in your area
when the CHANNEL (+), (–) buttons
are pressed.
Note: Make sure the antenna or cable
signal connection has been completed
before AUTO PROGRAM is activated.
Press the MENU button on the
remote to show the on-screen menu.
Press the CURSOR UP ▲ or
DOWN ▼ buttons to scroll through
the on-screen menu until the INSTALL
control appears on the screen.
Press the CURSOR RIGHT ᮣ
button. “Language” control will appear
on the screen.
Press CURSOR UP ▲ or DOWN
▼ buttons to scroll the Install features
until the AUTO PROGRAM control
appears on the screen. Whatever chan-
nel you are tuned to at the time will
appear within the Auto Program con-
trol.
Press the CURSOR RIGHT ᮣ
button to start the Auto Program scan-
ning of channels. Auto Programming
will store all available channels in the
TV’s memory, then tune to the lowest
available channel when done.
When finished, press the STATUS
/EXIT button to remove the menu
from the TV screen.
Try it out. Press the CHAN-
NEL (+), (–) buttons and see
which channels have been added to the
TV’s memory.
If you want to delete any unwanted chan-
nels from the TV’s memory, refer to the
section on adding and removing channels
(Channel Edit) on the next page.
S MART H ELP