Medela Classic Breastpump - Manual (Page 11)

5 5 Slip rubber seal onto piston
until it snaps into place. The
side with the larger diameter
faces the handle. A yellow
ridge should be visible above
the seal if rubber seal sits prop-
erly. After assembly, hold the
rubber seal firmly and twist the
piston to ensure the seal is seated properly.
6 6 Slide vacuum regulator ring
onto cylinder, if not already
done. Push handle end of piston
into cylinder.
7 7 Screw the cylinder into the back
of the connector.
8 8 Center breastshield(s) over
nipple(s) and start pumping.
This kit includes everything you need to manual breast-
pump. Follow the instructions and assemble as shown below
for Lactina Pumping System.
Manual Breastpumping
1 1 Snap white membranes onto
yellow valves until membranes
lie completely flat. Be sure to
separate membranes and valves
when cleaning.
2 2 Push valves into place on
breastshield (if 1-piece breast-
shield) or on connectors (if
2-piece breastshield).
3 3 If using the 1-piece breastshield,
insert the small end of the
PersonalFit breastshield into the
small end of the Connector.
(Prior to cleaning, separate
these two pieces.)
4 4 Screw containers onto breast-
shield or use disposable
Collection Storage and Freezing
(CSF) Bags, article #87010 or
#87013 (sold separately).
19 18
Vacuum Regulator Ring