MACKIE M1400/M1400i - Manual (Page 17)

17
Unbalanced TS (tip-sleeve) lines can be ac-
commodated via the TRS jack. Make sure the
cord terminates with a TS plug (like a guitar
plug), or if it’s a TRS plug (like a headphone
plug), make sure the ring is tied to the shield,
preferably at the source.
TIP SLEEVE
TIP
SLEEVE
SLEEVE (SHIELD)
TIP (HOT)
RING (COLD)
Unbalanced 1/4" TS Plug
You can connect an unbalanced XLR cable
to the M•1400/M•1400i, although this would
be unusual — as unusual as an unbalanced
XLR output.
The M•1400/M•1400i amp expects to see
a nominal signal level anywhere between the
–10dBV “semipro” and +4 dBu “pro” standards,
meaning almost any line-level mixer or other
device can be plugged into the amp’s
INPUTs.
Use the GAIN controls to adjust the gain of
the amplifier to match the signal level you’re using.
If you set the AMP MODE
switch in MONO or
BRIDGE, use the CHAN-
NEL 1 inputs only — the
CHANNEL 2 inputs are
disabled in this case.
CHANNEL
2 1
CHANNEL
63Hz
125Hz
CONSTANT DIRECTIVITY
HORN EQ /AIR EQ
CONSTANT DIRECTIVITY
HORN EQ /AIR EQ
INPUT
THRU THRU
INPUT
AMP MODE
FREQUENCY
4.5 k Hz
ON
6k Hz 2k Hz
MONO
(CHS SUMMED)
BRIDGE
LIMITER (CH1 & CH2)
OFF
FULL
RANGE
SUB
WOOFER
LOW CUT
FILTER
LOW CUT
FILTER
OUTPUT APPLICATION
BALANCED
OR
UNBALANCED
BALANCED
OR
UNBALANCED
ON
/ BRIDGE / MONO
170 Hz OFF
4.5k Hz
6k Hz 2k Hz
170 Hz
100 Hz
OFF
STAGE
MONITOR
100 Hz
STAGE
MONITOR
OFF
TYPICAL
ON
OFF
TYPICAL
TYPICAL
35 Hz
TYPICAL
35 Hz
STEREO
TYPICAL
STEREO
TYPICAL
AIR EQ AIR EQ
When connecting a balanced signal using
the XLR or 1/4" jacks, they’re wired thusly, per
AES (Audio Engineering Society) standards:
XLR TRS
Hot (+) Pin 2 Tip
Cold (–) Pin 3 Ring
Shield (Ground) Pin 1 Shield
2
2
3 1
1
SHIELD
COLD
HOT
SHIELD
COLD
HOT
3
SHIELD
COLD
HOT
3
2
1
Balanced XLR Connectors
Balanced 1 ⁄ 4 " TRS Plug
SLEEVE (SHIELD)
TIP SLEEVE
TIP (HOT)
RING (COLD)
RING
TIP
SLEEVE RING