Miele KFN 8992 SD ED - Manual (Page 44)

^ Pull off the cover g, and unscrew the
hinge bracket h.
^ Insert the pin i into the second hole
of the hinge bracket h.
^ Rotate the steel angle j and the
cover k 180° each, then fit them on
the opposite side.
^ Screw the hinge bracket h on the
opposite side. The M4 screw must
be screwed into the left hole of the
hinge bracket.
^ Now rotate the cover g 180° and
mount it on the opposite side.
^ In the middle of the appliance,
exchange the cover l and the
bearing bracket m, as follows:
Unscrew the cover l and the
bearing bracket m, rotate them 180°,
and screw them into place on the
opposite side.
^ Pull the bearing bushing n
downward and out of the bearing
bracket m, then re-insert it into the
bearing bracket from the top.
^ Remove the plugs from the door
bearing bushings at the top of the
appliance doors, and fit them into
place on the opposite side.
^ Hang the upper appliance door on
the pin i, and close the appliance
door.
^ Insert the middle bearing pin e
through the bottom of the bearing
bracket m in the upper appliance
door.
^ Check to see that the upper
appliance door is properly aligned.
Make any needed adjustments by
using the length holes in the bearing
bracket m.
^ Hang the lower appliance door on
the pin e, and close the appliance
door.
^ Insert the lower hinge bracket b in
the door bearing bushing in the lower
appliance door, and screw it
completely onto the housing.
^ Snap on the cover a.
Changing the door hinging
44