MITSUBISHI ELECTRIC WS-48513 - Manual (Page 25)

2-1
Chapter 2
Alignment Procedures
With the exception of the Service Menu access codes,
the general alignment procedures for the V23 chas-
sis remains the same as previous HD chassis. A chart
showing all recent Service Menu Access Codes is
provided on page 12 of the Introduction. This chap-
ter will give an overview of the following alignment
procedures.
• Initial Setup - Option Menu
• Circuit Adjustment Mode
• Convergence Adjustment Mode
• Alignment Data Storage Locations
For specific alignments, refer to the Service Manual.
Initial Setup
Option Menu - Initial Setup
Prior to alignment, the procedures for initial setup
should be followed so that all customer Main Menu
and A/V settings are set to the factory defaults listed
in Table 2-1 and Table 2-2.
Follow the steps below for the initial set-up:
1) Select the "MENU" display by pressing the
"MENU" button once.
2) Press the number buttons "0", "3", "7", "0"
in sequence to select the "OPTION MENU"
display. See Figure 2-1.
3) Press the "ADJUST" button to select "INI-
TIAL."
4) Press "ENTER."
NOTE: At this time, all Main Menu and A/
V settings will be set to the factory default
settings and channel 3 will be automatically
selected.
(MENU-0-3-7-0)
OPTION MENU
Initial
Power restore
:OFF
DTV Port :Auto
Figure 2-1: Option Menu