Marantz SA-7S1 - Manual (Page 14)

9
ENGLISH
REAR PANEL
A ANALOG OUTPUTS UNBALANCED connectors
These are the unbalanced output jacks of the analog au-
dio signals. The analog connection cord can be connected
to the CD, AUX, or other connectors on an amplifier. Be
sure to connect the L and R channels correctly to the cor-
responding jacks.
* Never connect to the PHONO connector on the ampli-
fier.
B ANALOG OUTPUTS BALANCED connectors
These are the balanced output jacks of the analog audio
signals. A balanced connection cord (available commer-
cially) can be connected to the balanced input jack of the
amplifier. Be sure to connect the L and R channels cor-
rectly to the corresponding jack. (See page 22)
* If connecting the balanced output jacks, be sure to leave
the unbalanced jacks unconnected. (The balanced and
unbalanced connectors cannot be used at the same time.)
C EXT. CLOCK INPUT (External clock)
Connector
This is the input connector for the clock frequency from an
external master clock generator.
Connect the master clock generator to the BNC terminal
coaxial cable (75
Ω ).
D DIGITAL OUTPUTS COAX.
(Coaxial digital output connector)
The audio CD signal being played is output digitally. Con-
nect a recording device, amp, D/A converter etc. that has
a coaxial digital input connector using a commercially avail-
able coaxial cable.
* No signal is output when Digital Out OFF is set.
* No signal is output when playing a super audio CD.
A B C D E F
NAMES AND FUNCTIONS
E DIGITAL OUTPUTS OPT.
(Optical digital output connector)
The audio CD signal being played is output digitally. Con-
nect a recording device, amp, D/A converter etc. that has
an optical digital input connector using a commercially
available square-shaped optical cable.
* No signal is output when Digital Out OFF is set.
* No signal is output when playing a super audio CD.
F AC POWER INPUT JACK
Connect the supplied power cord to this jack and a house-
hold AC power outlet.
06.8.29, 1:51 PM Page 9