Mellerware VAC20002000W - Manual (Page 4)

Use and function
A Guide to Assembling
Caution:
Be sure to cut off power and dismantle accesso-
ries before assembling.
Join hose and cleaner by means of joining hose at
suction inlet .
(Fig. 1)
Insert the hose into the suction and turn it clock-
wise.
Assembling hose handle to extension tube:
To attach the hose handle to the extension tube,
insert the bottom of the hose handle into the top
of the extension tube (as shown in figure 2). The
amount of suction may also be adjusted by using
the air regulator vent on the hose handle.
(Fig. 2)
Control of suction force:
Caution:
Once all the accessories have been attached to
the the appliance, remove the desired length of
cord required. The yellow mark on the cord is the
recommended ideal cord length. The cord should
not be removed beyond the red mark.
1. Insert the power plug;
2. Press down the switch button of the cleaner,
keep it ON ; make the suction power stronger
by turning it clockwise and make weaker by
turning it anticlockwise.
(Fig. 3)
3. Ideal cord reel method is as follows: Place plug
in one hand and using the other hand, press
cord reel button to rewind cord. By keeping the
plug in one hand, this allows cord to be retract-
ed properly and not allow cord to get tangled
during rewind process.
4. Thermal cut-out:
This appliance has been fitted with a thermal cut-
out to protect the motor from destruction or harm,
should the operating temperature exceed the safe
operating temperature. If the appliance cuts out, re-
move the plug from the socket and allow the appli-
ance to cool down. Also check all piping and tubes
for obsticles blocking or restricting airflow. Clean out
bagless dust compartment and HEPA filter. Allow the
appliance to cool down for 1 hour before reuse.
Move and transporting the appliance:
Caution:
A special handle is provided with this appliance
which will enable you to move and transport this
appliance comfortably. There is also a specially
designed grip handle on the bagless dust compart-
ment to move or transport the appliance. Please
note: Do not use the grip handle of the bagless dust
compartment to move or transport the appliance.
This can cause damage to the compartment as well
as cause the appliance to malfunction.
(Fig. 4)
Cleaning the HEPA filter:
Warning:
Before any cleaning is done, please ensure that the
appliance is switched off and that the appliance plug
is removed from the socket.
1. Press the release button of the bagless dust
compartment, found on the dust grip handle.
Remove the bagless dust compartment from
the appliance. Release the button of the ba-
gless dust compartment once compartment
has been fully removed.
2. Once the compartment has been removed,
open the hatch of the compartment to empty all
dust and dirt as shown in Fig. 6.
(It is essential to empty bagless dust compartment
once dust level reaches maximum capacity. Also re-
move HEPA filter and clean separately.)
Switch button Cord rewinder
button
VAC2000_IM.indd 4 VAC2000_IM.indd 4 2010/11/22 08:35:50 AM 2010/11/22 08:35:50 AM