Miele Refrigerator with Dynamic cooling K9752 - Manual (Page 44)

On furniture with door fittings (e.g.
stubs, seals etc) the dimension of
these must be taken into account when
making sure there is a gap all round of
42 mm.
^ Pull the appliance forwards by the
dimension of the door fitting to keep
the gap at 42 mm all round.
The hinges and the covers will now
protrude by the dimension of the door
fitting.
Tip: Removing the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
If the all round gap of 42 mm is not
maintained between the appliance
casing and the front edge of the
housing unit side wall the door may
not shut properly.
This could lead to a build-up of ice
and condensation and also cause
operational faults.
^ Align the appliance height on both
sides by altering the adjustable feet
using the spanner supplied c.
Securing the appliance in the
niche
^ Press the appliance against the
housing unit wall on the hinge side.
^ To fix the appliance to the housing
unit at the top and bottom, screw the
long 4 x 20 mm chip board screws a
into the hinges at the top and bottom.
Building in the appliance
44