Miele Refrigerator with Dynamic cooling K9752 - Manual (Page 34)

Before installation
^ Before installation remove the cover
strip, sealing strip and other
accessories from inside the
appliance and from the external rear
wall of the appliance.
^ Do not remove the following from the
back of the appliance:
– The spacers.
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– Depending on model, the bags
located between the back of the
appliance and the metal grille (heat
exchanger). They are important for
the correct functioning of the
appliance. The contents are
harmless and do not contain toxic
gases.
^ Remove any cable clips from the
back of the appliance.
^ Remove the red transport fixing a,
and use the stopper supplied b to
plug the empty hole.
^ Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
Does your old appliance have
a different hinging
mechanism?
If your old appliance had a different
type of hinging, the furniture door can
still be used. Remove the old hinges
from the housing unit. They are no
longer required because the furniture
door is now fitted to the appliance door.
All the necessary parts are supplied or
can be ordered from the Miele Spare
Parts Department.
Installation
34