MK Sound K-15 K-7 - Manual (Page 16)

Wall Mounting Bracket Template and Instructions
OUTLINE OF SPEAKER CABINET
LEVEL TEMPLATE TO THIS LINE
5"
7/8"
CENTER OF CABINET AND WALL STUD
WALL BRACKET
MOUNTED UP
DRILL 3/32" PILOT HOLES HERE
(FOR WALL ANCHORS, DRILL 1/8" HOLES)
1. If possible, we recommend mounting the
wall bracket to a wall stud. If you are using
a stud, locate the center of the stud.
2. Place this template on the wall and using a
carpenter's level adjust the template until
the top line is level. If you are mounting
the bracket to a wall stud, line up the
bracket holes with the center of the stud.
3. Tape this template to the wall, on all four
corners and recheck to make sure it is still
level. Readjust the template if necessary.
4. If you are mounting the bracket to a wood
stud, drill two 3/32" pilot holes.
5. If you are mounting the bracket with the
plastic anchors, drill two 1/8" holes per
bracket. (Use the plastic anchors only if
you are not able to mount the bracket to a
wall stud.)
6. Drill the pilot holes right through this paper
template.
7. Carefully remove the template from the
wall.
8. Position the bracket over the pilot hole and
secure in place using the supplied wood
screws.
9. If you mounting the bracket to the dry wall,
insert the plastic wall anchors into the 1/8"
pilot holes and drive the anchor into place
using a Philips screwdriver until they are
flush with the wall.
10. Using the supplied #6 x1-3/4" screws,
mount the bracket to the wall. Be careful
not to force the plastic anchors through the
wall or over tighten the screws.
11. Attach the speaker wires to the speaker.
12. Place the back of the speaker (with the
other component of the bracket in place)
and carefully slide the speaker down the
wall until the brackets mate.
K-Series Manual.qrk
04/16/02 rev.2 pt/qrk
PN: 70002
16
K-SERIES SATELLITE SPEAKER