Motorola CDMA 800/1900 MHz - Manual (Page 22)

22 May 15, 2006 6809495A97-O
Disassembly Q CDMA
3. Insert the disassembly tool between the front and rear housings and rotate it
at the places indicated (as shown in Figure 9) to release the housing snaps.
Press on the front housing and then pull the front and rear housings apart.
4. Lift the top end of the rear housing, and then the bottom end away from the
phone.
5. To replace, align the rear housing to the phone.
6. Carefully press the rear housing onto the phone until all the housing snaps are
fully engaged.
7. Insert 6 T6 screws into the rear housing assembly and tighten to 14 Ncm
(1.25 inch-pounds).
8. Replace the battery and battery door as described in the procedures.
060195o
Figure 9. Removing the Rear Housing Latches
Disassembly tool
Rear housing
3
4
4
4
2
1