Magnadyne M1-LCD - Manual (Page 6)

6
Remote Control Button Locations and Functions
(Continued)
12. Numeric Keypad: Inputs the corresponding
number.
13. Automatic Station Memory (ASM): Press and
hold for automatic station memory storing.
Press and release for scanning memorized sta-
tions.
14. Traffic Announcement (TA): Activates the traf-
fic announcement function. (See the Radio
Operations section for more information).
15. Weather Band (WB): Press for direct access to
the weather band radio.
16. Eject: Ejects the loaded disc.
17. Camera: Press to change the source to camera
mode.
18. Mode: Scrolls through the available sources.
19. Audio: Changes the language on multi-lan-
guage DVD discs.
20. Display: Displays source information.
21. Title: Displays the title menu that is stored on
the DVD disc.
22. Setup: Access the Bass, Treble, Balance, Fader
and Subwoofer controls.
23. Ok: Confirms the selected item.
24. Cursor: Moves feature selection up, down, left
or right.
25. Select (SEL): Accesses the Sound menu.
26. DVD/Menu: Displays the DVD menu.
27. Play/Pause: Starts and pauses disc play.
28. Stop: Stops disc play.
29. Slow Motion: Slow motion forward or reverses
playback of DVD disc.
30. Tune/Track/Chapter:
Radio: Press and the tuner will scan to the
next strong station and stop. Press and hold
until “MANUAL” appears in the display then
release. Then press again until the desired
radio station is tuned-in.
CD: Press to change to a lower or higher track.
DVD: Press to change to a lower or higher
chapter.
31. Enter/Band and Loud Button:
Radio: Selects AM1, AM2, FM1, FM2 and FM3
radio bands.
Loudness: Press and hold button until “LOUD”
appears in the display to boost high and low
tones at low volume levels. To deactivate, press
and hold again until “LOUD OFF” appears in the
display.
IPOD Mode: See “IPOD Operation” for more
information.
29. Program Type (PTY): Activates the PTY screen
which scans FM radio stations according to
program type.
System Setup
System Setup provides special settings to fine-tune
the user experience. Press and hold the power
button for more than 10 seconds. The System
setup display will appear. Select each item you
wish to adjust by touching the item button. Touch
the ᮣᮣ or ᮤᮤ arrow button to change the settings.
Press the back button to return to the previous
screen.
Beep Tone:
When the buttons are touched, the unit will emit
a beep. To change this feature press the BEEP
TONE button which will highlight this feature then
touch the ᮣᮣ or ᮤᮤ buttons to turn the beep
tone on or off.
Hold
M1-LCD-UM Rev. B (RGB):9900CD Manual 9/3/08 10:41 AM Page 6