MITSUBISHI ELECTRIC CP700E - Manual (Page 62)

61
7. Setting the functions (Memory SW menu)
CLEAR KEY ( Memory and Clear )
Function Setting the CLEAR button function on the remote control.
ONE ........ Pressing the CLEAR button on the remote control, the
memorized image being selected is cleared.
ALL ......... Pressing the CLEAR button on the remote control, all of the stored
memorized images are cleared.
3 SIGNAL ADJ Signal setting display
IN SYNC
Function Selecting the level of input sync.signal.
0.3 V ............ Composite Sync. of 0.3Vp-p level
TTL. SOG ..... Composite Sync. of TTL level or Sync. On. G
Set the function according to inputting signal.
OUT SYNC
Function Selecting the level of output Composite Sync. signal of RGB signal.
0.3V ........ 0.3 Vp-p
TTL ......... TTL level
Set the function according to connecting monitor.
S Y N C
Function Select the polarity of output H+V Sync. of RGB signal.
POSI ............. Positive polarity
NEGA ............ Negative polarity
Set the polarity according to the signal of the connecting device.
Refer to the manual of connecting device.
RGB SOG OUT
Function Select the sync. signal of RGB analog output terminal.
OFF............ Composite Sync. signal output
ON.............. Sync. On.Green + Composite Sync. signal output
This is the function to switch between sending and not sending Sync. On Green signal on the output
signal. When set to “ON”, Sync. On Green and Composite Sync. signals are output. When set to “OFF”,
only Composite Sync. signal is output.
Set the function according to connecting monitor.