Midland Radio 1001z - Manual (Page 10)

10
BACK PANEL
ANTENNA CONNECTOR: Connect a standard 50-ohm CB antenna to this
connector.
EXT SP: When a speaker is connected to this jack, the internal speaker
is by-passed. All received signals will be heard through the
external speaker. The speaker connected to the “EXT” jack
should be rated at 8 ohms and 5 watts.
PA JACK: An optional PA speaker may be attached to your transceiver
through the PA output jack on the back panel. This allows you to
communicate with pedestrians or other vehicles through your CB
microphone. The speaker connected to the “PA” jack should be rated at 8
ohms and 5 watts.
DC 13.8V POWER Cord: Connects to power cord with in line 2 Amp fuse.
HOW TO OPERATE YOUR TRANSCEIVER
You should become familiar with the controls and complete the preceding
installation instructions before attempting to operate your CB.
1. Rotate the on/off volume control clockwise to turn the unit on.
2. Adjust the squelch control fully counter-clockwise so noise is heard.
3. Adjust the volume for a normal listening level.
4. Rotate the squelch control until the noise just disappears.
5. Select the desired channel by rotating the channel selector.
6. To transmit, press the PTT bar on the side of the microphone. Hold the
microphone 2 to 3 inches from your lips and speak in a normal voice.
7. To receive, simply release the PTT bar.
Warning: Do not attempt to make any internal adjustments. Internal adjustments and/or
modifications can lead to illegal operation as defined by the FCC rules and regulations, Part 95.
They must be made only by qualified technical personnel. Illegal operation can lead to serious
consequences.
TECHNICAL SPECIFICATIONS
GENERAL
Frequency range ..........................................................................26.965-27.405 MHz
Channels ..............................................................................................................40
Modulation type ...................................................................................................AM
Antenna impedance .......................................................................................50 Ohm
Loudspeaker ...................................................................................................8 Ohm