Monte Carlo Fan Company 5GMR52XXD Series User Manual
Page 4
Install wall control unit to outlet box
using machine screws provided.
29
Attach front cover to wall control
with screws provided.
Twist lower cover plate into place by
twisting in direction of arrow.
Replace 1 screw removed and tighten
all 4 screws securely.
21
30
Check the motor for shipping stabilizer
and remove if present. The screws, wash-
ers and motor pads are pre-installed to
the blade holders. Attach blade assembly
to motor and tighten screws securely.
19
Remove cover by snaping off from
top or bottom. Install 12V battery
into wall remote. Duracell MN21 /
Eveready A23 / GP 23A all 12V.
27
Attach cover of remote by placing
over buttons and snaping into place.
28
Loosen 4 screws on lower cover
plate.
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
22
23
Place glass on light kit, hold in place
and tighten finial cap in direction of
arrow.
26
Install the 2 x 50 watt halogen
bulbs. Do not touch bulb surface as
oily residue from skin can cause the
bulb to explode.
25
Place light kit over screws and twist
direction of arrow into place. Then
tighten all 4 screws securely.
24
Loosen 3 screws with key slots and
remove the 1 screw with closed slot.
Save screw removed.
20