Warning – McCulloch 115145929 User Manual

Page 8

Advertising
background image

-- 8 --

To oil the blade, do the following:
S

Stop the engine and allow blade to come to

a complete stop.

S

Ensure ON/OFF switch is in the OFF posi-

tion.

S

Disconnect the spark plug wire.

S

Apply a light machine oil along the edge of

the top strap as shown.

Top Strap

OIL

ENGINE

S

Remove spark plug and pour 1 teaspoon of

40:1, 2-cycle engine oil (air cooled) through

the spark plug opening. Slowly pull the

starter rope 8 to 10 times to distribute oil.

S

Replace spark plug with new one of recom-

mended type and heat range (see RE-

PLACE SPARK PLUG section).

S

Clean air filter.

S

Check entire unit for loose screws, nuts,

and bolts. Replace any damaged, broken,

or worn parts.

S

At the beginning of the next season, use

only fresh fuel having the proper gasoline to

oil ratio.

OTHER

S

Do not store petrol from one season to

another.

S

Replace your petrol can if it starts to rust.

TROUBLE

CAUSE

REMEDY

Engine will not

start.

Engine will

not idle

properly.

1. Carburetor requires

adjustment.

2. Crankshaft seals worn.

3. Compression low.

1. See “Carburetor Adjustment” in

Service and Adjustments Section.

2. Contact an authorized service dealer.

3. Contact an authorized service dealer.

1. Air filter dirty.

2. Spark plug fouled.

3. Carburetor requires

adjustment.

4. Carbon build-up on

muffler outlet screen.

5. Compression low.

Engine will not

accelerate,

lacks power,

or dies under

a load.

1. Clean or replace air filter.

2. Clean or replace plug

and regap.

3. See “Carburetor Adjustment” in

Service and Adjustments Section.

4. Contact an authorized service dealer.

5. Contact an authorized service dealer.

Engine

smokes

excessively.

1. Choke partially on.

2. Fuel mixture incorrect.

3. Air filter dirty.

4. Carburetor requires

adjustment.

1. Adjust choke.

2. Empty fuel tank and refill with

correct fuel mixture.

3. Clean or replace air filter.

4. See “Carburetor Adjustment” in

Service and Adjustments Section.

Engine runs

hot.

1. Fuel mixture incorrect.

2. Spark plug incorrect.

3. Carburetor requires

adjustment.

1. See “Fueling Engine” in Operation

section.

2. Replace with correct spark plug.

3. See “Carburetor Adjustment” in

Service and Adjustments Section.

WARNING:

Always stop unit and disconnect spark plug before performing all of the

recommended remedies below except remedies that require operation of the unit.

TROUBLESHOOTING TABLE

1. ON/OFF switch in the

OFF position.

2. Engine flooded.

3. Fuel tank empty.

4. Spark plug not firing.

5. Fuel not reaching

carburetor.

6. Carburetor requires

adjustment.

1. Move ON/OFF switch to the ON

position.

2. See “Starting a Flooded Engine”

in Operation Section.

3. Fill tank with correct fuel mixture.

4. Install new spark plug.

5. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;

repair or replace.

6. See “Carburetor Adjustment” in

Service and Adjustments Section.

Advertising
This manual is related to the following products: