Miele CS1411 - Manual (Page 35)

,
CAUTION: Before installation or
servicing, disconnect the power
supply by either removing the fuse,
shutting off the main power or
manually "tripping" the circuit
breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the rating label correspond with the
household electrical supply. This
data must correspond to prevent
appliance damage. Consult an
electrician if in doubt.
Only operate the appliance after it
has been installed into the
countertop.
Installer:
Please leave these instructions with
the consumer.
Power supply
^ Be sure your electrical supply
matches the rating label.
The rating label is located on the
underside of the appliance.
The combiset is equipped with a power
cord encasing 3 wires ready for
connection to a grounded power
supply.
They must be connected to a
dedicated line through the use of an
approved junction box.
Black : connect to L1 (hot)
Red:
connect to L2 (hot)
Green: connect to GND (ground):
240 V, 60 Hz, 15 A fuse rating
Be sure the power outlet is accessible
after installation.
For further information, see the wiring
diagram provided with the appliance.
, WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Electrical connection
35