Minolta CF911PE - Manual (Page 16)

1-2
Saf
ety
N
o
te
s
Ch
a
p
te
r 1
CF911PE Operator’s Manual
1. Installing the Printer
Installation Site
To ensure optimal safety and prevent possible malfunctions of the unit, install the printer in a location
which meets the following requirements.
Power Source
The power source voltage requirements are as follows.
◆ Use a power source with little voltage fluctuation.
Voltage Fluctuation : Within ± 10% (for U.S.A. and Canada)
Specified voltage ± 10% (For EU)
Frequency Fluctuation : Within ± 0.3% (For U.S.A. and Canada)
Specified frequency ± 3Hz (For EU)
Space Requirements
To ensure easy printer operation, supply replacement and service maintenance, observe the recommended
space requirements detailed below.
* Be sure to allow a clearance of 150 mm (6") or more at the back of the printer as there is a ventilation
duct.
◆ A place away from a curtain or the like that may
catch fire and burn easily.
◆ An area where there is no possibility of being
splashed with water or other types of liquid.
◆ An area free from direct sunlight.
◆ A place out of the direct air stream of an air
conditioner, heater, or ventilator.
◆ A well-ventilated place.
◆ A dry place.
◆ A dust-free location.
◆ An area not subject to undue vibration.
◆ A stable and level location.
◆ A place where ammonia or other organic gas is
not generated.
◆ A place which does not put the operator in the
direct stream of exhaust from the printer.
◆ A place which is not near any kind of heating
device.
C4119O003AA
Scale: mm(inch)
1,543 (6-3/4)
622 (24-1/2) 921 (36-1/4)
1086 (42-3/4)
640 (25-1/4)
1,276 (50-1/4)
511 (20) 765 (30)
1,
02
4
(40-
1/
4)