MTX Audio 820W - Manual (Page 4)

STEP 1
Using a stud finder (available at low cost at most hardware stores) or other
accurate method, locate center point between two studs and mark. Using
template provided, trace hole pattern on surface of wall. Placing a bubble level
on either the horizontal or vertical guidelines of template will assist you in
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in wall,
STEP 3
Run loudspeaker wires to sound source location. There are several methods you
can use to accomplish wiring, depending on the construction characteristics of
the room or house. You can add a professional touch to your installation by
using a speaker terminal plate at the source location. Leave sufficient amount
STEP 4
Attach loudspeakers wires to speaker terminals, observing correct polarity
(positive to positive and negative to negative), and position panel and frame
assembly to hole as shown. Insert top of mounting frame into hole at top. By
moving bottom of frame upwards, you should now be able to insert bottom of
frame into hole at bottom. Be careful not to pinch loudspeaker wires in the
process. Tighten long screws. Use a level during tightening to insure
STEP 5
After speaker panel is secured tightly, test for sound.
STEP 6
When you are satisfied the speaker is operational, “aim” the tweeter, and affix
grill. As grill is designed for a snug fit, you’ll need to position one edge into
slot first, and press or squeeze around perimeter of grill, while pushing leading
edges into grill slot.