Motorola 9500 User Manual
Page 65
Using In-Call Features
61
You may see one of these messages:
Cellular
Mode
(CDMA/
AMPS)
To place a call on hold, you must send a phone
flash (see page 62 for more information) along with
the appropriate feature code provided by your
service provider. To return to your initial call, you
must send another phone flash. To send a phone
flash, see page 62.
Cellular
Mode
(GSM)
This feature is not available in GSM cellular mode.
End Current Call
Press
C
at any time.
End Call that is on
Hold
Press
M
until you will see
End
Held Call
, and then
press
O
to
select.
The held call is disconnected, the
current call remains connected,
and you see
End Call?
.
Message
Description
Trying
Your phone is attempting to switch
between the current and held call.
Hold
Failed
The attempt to hold a call was
unsuccessful.
Cannot Hold
Second Call
A call is already on hold. You can
only place one call on hold.
Reconnect
Failed
The held call could not be made
active again.
Busy
Try Later
Your phone is working on a
previous command. Wait a short
time before repeating the new
command.
If you want to...
Then...