Marantz DH9300 - Manual (Page 28)

26
ENGLISH
System Settings
Provides a series of menus to allow you to change the
hardware configuration on your Music Server:
The following table summarises the settings available on
each of the System Settings menus:
Output Settings
The volume setting of each individual output of the Music
Server may be configured as either variable or fixed.
If the volume setting is set to fixed the output level is set to
maximum and the balance is set to the central position. In
this mode the N and O Mute keys on the Music Server
remote control do nothing*.
If the volume setting is set to variable the output level can
be altered at any time using the N and O Mute keys on
the Music Server remote control. A Balance option is also
available from the Volume Settings menu which allows you
to adjust the left/right balance.
*Note: The Music Server remote control can be configured
so that when the HDD Audio device is selected the N and
O Mute keys operate the volume and mute controls on an
amplifier. For more information see the chapter called
Configuring your remote to control other devices p.11.
Option Description
Network Mode
Specifies whether your Music Server
connects to the Internet via the built-in
modem or using the Ethernet port.
Modem Settings
Allows you to specify the following settings
when connecting via the built-in modem:
number of connection retries, the Assigned
IP address and the Server IP address, the
modem initialisation string, and whether to
use tone or pulse dialling.
Ethernet Settings
Allows you to specify the following settings
when connecting via the Ethernet port: IP
address mode, IP address, IP Mask,
Gateway, IP DNS1, IP DNS2.
Controller Settings
Specifies the communication speed for the
Controller port on the rear of the unit.
Video settings
Specifies whether the unit is configured for
PAL or NTSC use.
Remote Diagnostics
Select this option if instructed to set up
your modem to receive incoming calls from
Marantz technical support staff.