Master Appliance PH-2200 - Manual (Page 4)

clothes. Wash hair and
body thoroughly with soap
and water.
12. WARNING: To reduce the
risk of fire or electric shock,
do not expose heat guns to
rain or moisture. Store
indoors. Connect to
grounded outlet only.
13. Do not use plug adapters
or remove the ground
prong from the plug. This
tool is equipped with a 3-
prong plug and a 3-wire
grounding system. Connect
to properly grounded
outlets only.
14. Use heat gun only on
adequately rated circuits to
avoid overheating of
electrical systems.
15. Proheat heat guns can
produce up to 1050°F of
flameless heat out of the
nozzle. Do not direct this
hot air stream at your
clothing, hands or body
parts. Do not use as a hair
dryer.
16. Do not touch nozzle
opening or nozzle shield
until cool. When in “Hot”
mode, extreme heat is
generated at those areas.
Always hold tool by the
handle or use permanently
attached stand.
17. Run on cool before turning
off. The nozzle and shield
require approximately 3
minutes to become cool to
the touch. Stand the unit on
its end with the nozzle
pointing upward after
turning off.
18. Do not touch work surface
with nozzle. Scrape paint
with nozzle face at least 1”
away.
19. Keep a clean work area.
Messy or cluttered work
areas invite accidents or
injury.
20. Keep away from children.
All visitors should be kept at
a safe distance from the
work area. Do not let
visitors touch the tool or
extension cord.
21. Use tool in a well-ventilated
area. Do not use near
flammable liquids or in an
explosive environment
(where fumes, gases or
dust are present).
22. Remove all highly
flammable materials and
other debris from the work
area.
23. Wear safety glasses at all
times.
24. When using an extension
cord, use only a 3-wire
grounded cord with a
minimum of 14-gauge
capacity. We recommend
they be listed by Under-
writers Laboratories (UL) in
the U.S.A. or (CSA)
Canadian Standards
Association in Canada and
be suitable for outdoor use.
Cords marked for outdoor
use are also suitable for
indoor use.
25. Don’t abuse cordset. Never
pull by cord to remove from
electrical outlet or carry tool
by cord.
26. When not hand-held, place
tool on a level surface.
Position cordset so it does
not cause tipping.
27. Keep a fully-charged fire
extinguisher close at hand.
4
Important Safety Instructions
(cont’d)
28. Do not leave heat gun
unattended while it is
running or cooling down.
29. Stay alert. Do not operate
tool when you are tired. Use
common sense and watch
what you are doing.
30. Store properly. Do not store
while hot. Store in a dry,
high or locked-up location.
Keep out of the reach of
children.
31. Always unplug tool before
performing any
maintenance. When
servicing, use only Master
Appliance brand
replacement parts. We
recommend that all
maintenance be performed
by a qualified repair
technician who is
experienced in the repair of
electric tools, a qualified
service organization, or our
repair staff.For Factory
Repair Service, send
product to:
32. WARNING: THIS PRODUCT,
WHEN USED FOR SOLDERING AND
SIMILAR APPLICATIONS, PRODUCES
CHEMICALS KNOWN TO THE STATE
OF CALIFORNIA TO CAUSE CANCER
AND BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
Save These Instructions.