Microsoft DS5 - Manual (Page 11)

DS5 User Guide
Drive Assembly - DS5
If your setup requires an internal drive, open the case and install a hard drive before
turning the unit on.
Note: Format the drive using FAT32 before installing it.
2.5” HDD or CF card
1. Lift the top cover off the body.
2. Take the drive module and insert your
CF card or the 2.5” HDD. Note: The
DS5 can not work with a CF card AND
hard drive installed together!
3. If your are installing the 2.5” HDD,
mount it with two screws from beneath.
4. Align the drive module with your DS5
and push it lightly into place, so that
the connector from your module fits
into the IDE connector on the DS5
bridge board. Mount it with the 4
screws as seen in the illustration below.
5. Align the top cover with the body and
push lightly into place.
Note: Be careful not to damage any cables or components during the installation!
Page 9 / Chapter 2 - Hardware Installation