Marantz Model SC-11S1 User Manual
Page 29
23
ENGLISH
HOW TO USE AND SET FEATURES
7
How to Trim Bass
The bass level of the left and right channels can be trimmed
in 2dB steps across a –8.0 – +8.0dB range. When this unit is
shipped from the factory, the bass level is set to 0 dB. To trim
the bass level, active tone control by pressing the TONE button
on either the unit or the remote controller.
1.
Press the TRIM button once to access the LEVEL trimming
mode.
2.
Press the ENTER button once to access the BASS trimming
mode.
3.
The flashing “0” on the left indicates that trimming is
activated for the left channel bass level. Press the
3
and
4
buttons to set the bass level of the left channel.
4.
Press the
2
button to start the “0” on the right side flashing.
When the right side “0” starts flashing, trimming is activated
for the right channel bass level. Press the
3
and
4
buttons
to set the bass level of the right channel.
5.
To trim the bass level of the ID 2 (slave) unit, press the
TRIM button again and set the bass level as in steps 2-4.
After that, pressing the TRIM button again allows you to
trim the bass level for the “ID 3” unit and so forth.
6.
When finished with bass level trimming, press the EXIT
button.
7
How to Trim Treble
The treble level of the left and right channels can be trimmed
in 2dB steps across a –8.0 – +8.0dB range. When this unit is
shipped from the factory, the bass level is set to 0 dB. To trim
the treble level, active tone control by pressing the TONE button
on either the unit or the remote controller.
1.
Press the TRIM button once to access the LEVEL trimming
mode.
2.
Press the ENTER button twice to access the TREBLE
trimming mode.
3.
The flashing “0” on the left indicates that trimming is
activated for the left channel treble level. Press the
3
and
4
buttons to set the treble level of the left channel.
4.
Press the
2
button to start the “0” on the right side flashing.
When the right side “0” starts flashing, trimming is activated
for the right channel treble level. Press the
3
and
4
buttons
to set the treble level of the right channel.
5.
To trim the treble level of the ID 2 (slave) unit, press the
TRIM button again and set the treble level as in steps 2-4.
After that, pressing the TRIM button again allows you to
trim the treble level for the “ID 3” unit and so forth.
6.
When finished with treble level trimming, press the EXIT
button.